You'll be happy with the 7491RS for sure. I built an outfeed table and an infeed table which have greatly enhanced the performance and versatility of this saw. I replaced mine with an Incra model that is excellent and added LeeCraft zero clearance inserts for tear out free work. The fence is a strong point on this saw, however the included miter gauge is worthless. Very little tuning was needed, but the adjustments are designed into this saw if needed. I took the time with a dial indicator to make sure that the miter slots are parallel to the blade and likewise for the rip fence. Of course the feed rate is slower than my old cabinet saw, but it is a well built tool for the compromises that have to be made with lightweight portable jobsite saws. Features Patented Material Support, Can Be Used For Narrow Rip Cuts 32-1/2 Rip Capacity Easily Cuts A Variety Of Larger Shelving And Trim Materials Rolling. Use a mark on the board to assure you are measuring from exactly same spot on board front and back. (5/8' hole a couple inches from one end) 4) Make initial measurements and write them down. I run full kerf Forrest WW II blades with out problems and it spins a full sized 8" dado just fine. 75' plywood arm in place of blade (use for measurements). It has really surprised me about how capable it is. I wanted to rip narrow pieces for face frame and door frames and got the 7491. I downsized from a 3HP Unisaw and went with out a table saw for a couple of years using only a track saw. If it is the 7491 RS, it is one great saw.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |